My vintage KDS-21 Kitchenaid dishwasher: 3 steps forward, 2 steps back

The other possible subtitle of this story is: I have some good news and some bad news. Which do you want to hear first?

I am a glass-half-full kind of person, so I will start with the good news:

I have a new-to-me vintage Kitchenaid dishwasher installed in the kitchen! Woooooot! Needing a new dishwasher and disgusted by the short lifespans of current dishwashers I turned to my tried-and-true method: Buy vintage.

To research this topic, the automaticwasher “Imperial” forum was my go-to place.  There are several of models that seem popular among the experts, including old Kitchenaid dishwashers still made by Hobart or using Hobart technology. These are apparently a DREAM in terms of longevity.

So I started regularly searching craigslist. Finally, I went for the pounce and recently, drove four-hours roundtrip to buy this beautiful KDS-21 Kitchenaid Superba dishwasher. The dishwasher was in wonderful condition — the seller was remodeling. I also got two original booklets, a use booklet and an installation guide.

My plumber Paul — who also had installed my Dishmaster — came the same week I called and was a dream to work with in terms of getting the dishwasher into the space and all hooked up. 

Okay, the bad news:

She won’t turn on. The KDS-21 Kitchenaid had been hard-wired. My plumber took the plug-in cord from my circa-2005 Bosch and wired it onto the Kitchenaid. Could this be the issue? Or — ??? We are sure there is electricity coming out of the plug. 

Mind the Gap: The plumber had to add wood supports to the bottom of the dishwasher to close the gap underneath my countertop. My floors are not level, so I recall that when we installed the cabinetry, the entire line of cabinetry along this wall had to be shimmed so that the countertop was level. The dishwasher has little adjustable legs on it that also can adjust the height. Even with those extended to their fullest point, we had a 5/8″ or so gap. Yes, I need to detail clean the dishwasher’s exterior.

Before I try and find someone locally who can help get my darling Kitchenaid going, I will be reaching out to automaticwasher for help. 

Another reason I went for this particular Kitchenaid model: The front panels can be changed out. I plan to swap out the white plastic (yes, that’s a sheet of some sort of plastic) for aquamarine-colored steel panel on my old dishwasher. The steel for that panel was taken from right from the side of an extra kitchen cabinet from my salvaged set. I will have to have the current one-piece panel cut into two-pieces to size — one for the door, one of the bottom plate (see top photo). 

Interestingly, I am not particularly annoyed by how this played out. After all, around here we do things The Hard Way. And even sans suds, I give this project “three steps forward” because golly, my vintage Kitchenaid dishwasher is so pretty. So collectible. So substantial. And assuming I can get her working: A proven workhorse! 

 

The post My vintage KDS-21 Kitchenaid dishwasher: 3 steps forward, 2 steps back appeared first on Retro Renovation.